Cmod EEPROM erased

[thierry33]

Hi Everyone,

I  accidentally flashed the EEPROM attached to the FT2232 device on one of our CMOD-S7 35, unfortunately it was just still in the USB-Port when I tried to flash an FT232H of another device. Does anyone has an idea how it 
can be restored back to Digilent factory setting?

Thank you very much, best regards

Thierry

[JColvin]

Hi @thierry33,

I have split your post into a new thread.

Could you clarify which device you have? Digilent does not have a Cmod S7 35. There is a Cmod S7 25 and a Cmod A7 35, so I do not want to provide incorrect instructions.

Thanks,
JColvin

[thierry33]

My device is  Cmod S7 25  and EEPRom  has been erased .And the cmod s7-35 is not detected by vivado. I think that eeprom has deleted by the software FT_prog.

Could you send me dump of the eeprom. thanks

[JColvin]

Hi @thierry33,

I have sent you a PM with some instructions.

Thanks,
JColvin

[FPGA]

Hi @JColvin,

I am experiencing the same issue as well. I have accidentally flashed the EEPROM on my Cmod S7 25. What steps can I follow to reset the device to factory configuration. 

[JColvin]

Hi @FPGA,

I have sent you a PM.

Thanks,
JColvin