Cannot upload bitstream due to wrong device

[Jarl Gjessing]

I have a ARTY A7 board but cannot upload bitstream to it.

I selected digilent as Vendor, and Arty A7-100 (On top of the FPGA there is a Artix-7 100T CSg324 label)

And loaded one of the demo files. It compiles fine and generate the bitstream, but says:

[Labtools 27-3303] Incorrect bitstream assigned to device. Bitfile is incompatible for this device. Bitstream was generated for device xc7z010i and target device is xc7a100t.
 

In fact I cannot find any devices with the ID xc7a100t under parts they are all xc7z

Edited January 29, 2023 by Jarl Gjessing
Added that I cannot find the ID at all

[zygot]

No mystery here: you selected a bistream file created  for a ZYNQ device and your board is not a ZYNQ device. If you started off with a demo for your board and selected the correct device your bitstream would be correct. There's very little likelihood of getting past synthesis, implementation or bitgen targeting the wrong device as pin assignments would not match.

4 hours ago, Jarl Gjessing said:

In fact I cannot find any devices with the ID xc7a100t under parts they are all xc7z

Where are you finding these?

If you look in the Vivado Project Settings, what device is listed?