Adp5250 continuity

[bryan78]

Is there a way to make the continuity check under DMM beep under a set resistance?  I don’t see a way to enable it.

[attila]

Hi @bryan78

There is no such option yet, but we can add it.

[bryan78]

7 hours ago, attila said:

Hi @bryan78

There is no such option yet, but we can add it.

That would be great.  Keep me from having to look up.  If you are able to add that can you also add the inverse, break detection.  So beep either for good continuity or set to beep when open based on adjustable values. Thanks

[attila]

Hi @bryan78

Until the option is added you can use a script like this:

DMM.run()
while(DMM.State.running() && wait(0.5)) if(DMM.Measure.value < 10.0) Tool.beep()
DMM.stop()

[bryan78]

Thanks for the latest feature.  May not be possible and also preference, but may be better if it latches the state until next check.  So it is a tone instead of constantly beeping.  Really like that it was also added to the voltages also, thanks.

[attila]

Hi @bryan78

It will be corrected in the next version.