Danny Sau Posted January 12 Share Posted January 12 I am using USB201, but MCC DRV is not showing under inputs/outputs. Link to comment Share on other sites More sharing options...
0 JRys Posted January 12 Share Posted January 12 Hello, Make sure InstaCal has the USB-201 is in its board list. Close InstaCal and run the DASYLab Configurator program. Click over to the Packages page, open the Data Acquisition section and enable the Measurement Computing driver. When you exit, the MCC driver installation will run. Check out the following KB article about the installation:https://kb.mccdaq.com/KnowledgebaseArticle50823.aspx Best regards, John Link to comment Share on other sites More sharing options...
Question
Danny Sau
I am using USB201, but MCC DRV is not showing under inputs/outputs.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now