I think the MOSI and MISO signals incorrect in the in the Board Files for the ADXL362 on the Nexys-A7 100T

[Brenden]

I was using the IP integrator to talk to the ADXL362 on the board. I did this by clicking on "Board > Accelerometer > Connect Board Component". When I Implemented the design I noticed that I could not talk to the ADXL362.

I eventually looked at the "IO - Place Design" report. It said that:

acl_io1_io (MISO) - F14
acl_io0_io (MOSI) - E15

Now this looks backwards to me. From the constraints and the schematic it looks like F14 = MOSI and E15 = MISO. It looks like the board configuration is wrong.

When I manually created the AXI SPI and used the constraints and wired F14 = MOSI and E15 = MISO I was able to communicate.

[artvvb]

Welcome to the forums!

Good catch, the issue has now been corrected in version 1.3 of the board files. Here's a link to the updated version of the board.xml file: https://github.com/Digilent/vivado-boards/blob/master/new/board_files/nexys-a7-100t/D.0/1.3/board.xml

Thanks!

Arthur