I need to calibrate an IOTech Tempscan/1000 and the manual says to set the 9th bit of DIP switch to allow calibration mode, but my unit does not have the 9th bit, there is a connector on the motherboard labelled CAL but I am unclear which pins to short in order to enable calibration mode. URGENTLY need help with this, we are down hard at the moment. Thx.
Question
drcoelho
I need to calibrate an IOTech Tempscan/1000 and the manual says to set the 9th bit of DIP switch to allow calibration mode, but my unit does not have the 9th bit, there is a connector on the motherboard labelled CAL but I am unclear which pins to short in order to enable calibration mode. URGENTLY need help with this, we are down hard at the moment. Thx.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now