Jump to content
  • 0

How to trigger the DAQ at the start of the chirp signal.



I am using python to communicate with Signal Generator and MCC DAQ 1602-HS.

I setup the chirp setting in the Signal Generator. Then I turn on. Immediately I turn on the DAQ next line. (using python). I couldn't capture the start of the chirp. The DAQ start capture after sometime. 

The example code DAQ_Set_Trigger() is so complicated for me. I can't understand. Can you please give me code that will trigger the DAQ when chirp signal from signal generator turns on?

I have attached my code below. 

Thank you.


Link to comment
Share on other sites

1 answer to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...