Need help with USB-5203 to read RTD

[minche]

Hi there,

I have followed the instructions to connect RTDs and thermocouples to USB-5203. I used Instacal to set up the channels for the RTDs and can read data through "test" in Instacal. But the configurations are not updated in DAQami, it only shows thermocouple options. I cannot read RTDs. I have tried multiple times and it still doesn't work. Need technical support ASAP!

[DAQman]

Hello,

To date, the USB-5203 is not fully integrated into DAQami to the point you can configure the channels. However, because it knows which device you have, it disregards its channel setup and instead uses InstaCal's. About all you can do is turn channels on/off and change the sample rate.  

Best regards,
John

[minche]

39 minutes ago, JRys said:

Hello,

To date, the USB-5203 is not fully integrated into DAQami to the point you can configure the channels. However, because it knows which device you have, it disregards its channel setup and instead uses InstaCal's. About all you can do is turn channels on/off and change the sample rate.  

Best regards,
John

Thanks, John, I tried, and it can read the correct RTD temperature.