dpate Posted September 20, 2022 Share Posted September 20, 2022 (edited) Hello, I am trying to see if there is a way in waveforms software with analog discovery 2 to record the time different between last time scope channel was triggered and current time it triggered. Thanks, Here is the trigger configuration Edited September 20, 2022 by dpate Link to comment Share on other sites More sharing options...
0 attila Posted September 21, 2022 Share Posted September 21, 2022 Hi @dpate The AD2 uses software timer to report the absolute trigger positions. Newer devices with larger FPGA (ADP3X50, EclypseZ7) use hardware timer with system frequency resolution. With AD2 (or any other device) you could drive Trigger IO with the Scope Trigger Detector, loop this to a DIO pin, use the Logic Analyzer with Record and data compression to capture up to 256MiS at max rate/resolution (100MHz). Link to comment Share on other sites More sharing options...
Question
dpate
Hello,
I am trying to see if there is a way in waveforms software with analog discovery 2 to record the time different between last time scope channel was triggered and current time it triggered.
Thanks,
Here is the trigger configuration
Edited by dpate
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now