I can start off with the calibration process and when I'm calibrating the W1. It measures -0.01V for 0V from the software and so on. At -5V the multimeter I use to calibrate the analog discovery devices shows -5.9V. After this the calibration prompt on the software says 0V but the output from the board does not go back to 0V or -0.01V. If I restart the Discovery 2, I will be able to measure -0.01V for 0V again. How do I successfully calibrate this device?
Question
Bnm
I can start off with the calibration process and when I'm calibrating the W1. It measures -0.01V for 0V from the software and so on. At -5V the multimeter I use to calibrate the analog discovery devices shows -5.9V. After this the calibration prompt on the software says 0V but the output from the board does not go back to 0V or -0.01V. If I restart the Discovery 2, I will be able to measure -0.01V for 0V again. How do I successfully calibrate this device?
Thanks
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now