I recently purchased a CMOD S7 and have been able to program it with my Verilog source code using Vivado. I'd like to connect to the Pmod OLED board to display a "success" or "Hello world" message. There doesn't seem to be any simple/ low level example hdl for this. All I can find is guidance to link to the Pmod using the Microblaze processor. These instructions are very lengthy and state " Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier." and i'm using 22.1 so I'm not even sure I should try.
Is there a simple verilog source to turn on the Pmod at a low level or would I have to write this from scratch?
Question
Jack1232345677
I recently purchased a CMOD S7 and have been able to program it with my Verilog source code using Vivado. I'd like to connect to the Pmod OLED board to display a "success" or "Hello world" message. There doesn't seem to be any simple/ low level example hdl for this. All I can find is guidance to link to the Pmod using the Microblaze processor. These instructions are very lengthy and state " Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier." and i'm using 22.1 so I'm not even sure I should try.
Is there a simple verilog source to turn on the Pmod at a low level or would I have to write this from scratch?
Many Thanks,
Jack
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now