Cold Fusion Posted July 9, 2022 Share Posted July 9, 2022 I recently purchased the Analog Discovery 2 USB scope and am dismayed by the noise on the screen. Even with the scope probe ground clip connected to the probe tip there is 20mVpp 60Hz noise present. Link to comment Share on other sites More sharing options...
0 JRys Posted July 11, 2022 Share Posted July 11, 2022 Hello, I did not see an input noise specification in the Analog Discovery 2 (AD2) Resource Center (reference page). However, when I do a similar test with the BNC adapter board and a scope probe (DC coupling), my results are 10 - 12 mVpp. This equates to roughly 4 counts of p-p noise where each count is 3mV. An FFT of the signal did not show a significant 60 Hz noise component however, if the probe is switched to 10x, then a 60 Hz component did appeared. regards... Link to comment Share on other sites More sharing options...
0 JColvin Posted July 12, 2022 Share Posted July 12, 2022 Hi @Cold Fusion, I presume you are using the BNC Adapter with the Analog Discovery 2 based on your description? This Forum thread may also be of interest to you as well: Thanks, JColvin Link to comment Share on other sites More sharing options...
Question
Cold Fusion
I recently purchased the Analog Discovery 2 USB scope and am dismayed by the noise on the screen. Even with the scope probe ground clip connected to the probe tip there is 20mVpp 60Hz noise present.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now