Andrzej Posted April 7, 2022 Share Posted April 7, 2022 Do you have the whole pcb layout? Link to comment Share on other sites More sharing options...
0 attila Posted April 7, 2022 Share Posted April 7, 2022 Hi @Andrzej If you are looking for the board size, see the 3D models at the bottom of the page:https://digilent.com/reference/test-and-measurement/analog-discovery-2/start For troubleshooting: For fixing information with some layouts: Link to comment Share on other sites More sharing options...
0 Andrzej Posted April 27, 2022 Author Share Posted April 27, 2022 Thanks for your help .After replacing the FT232HQ chip I get such an error.Is the description of these errors? Link to comment Share on other sites More sharing options...
0 attila Posted April 27, 2022 Share Posted April 27, 2022 Hi @Andrzej Probably other ICs on the device are damaged as well, like NC7SZ126 and/or the FPGA. On software connection the FPGA done flag is verified through JTAG. This bit should be low but in your case it looks like it is read as high. The DptiIO communication fails since with ERC 2 the FPGA is not programmed but I don't see the cause of the following connection retry error of 3077. You could try "Force programming" under right-click or Options in this Device Manager. This will skip the done flag verification and program the FPGA but this will probably also fail. Link to comment Share on other sites More sharing options...
0 Andrzej Posted April 28, 2022 Author Share Posted April 28, 2022 Thank you . attila 1 Link to comment Share on other sites More sharing options...
Question
Andrzej
Do you have the whole pcb layout?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now