Multiple sources for one AD2

[JEK]

I was wondering if it was possible to log acquisitions from Trigger 1 and Channel 1 on one AD2 at the same time. I am running a pulse from an EFG to trigger 1 and a ramp from that same EFG to Channel 1. I want to have corresponding ramp voltage measurements for each trigger acquisition in trigger 1. I have attached a picture of my setup.

Thank you

[attila]

Hi @JEK

1. The most accurate measurement would be by connecting EFG/Trig to the other AD2 Scope channel and triggering on rising edge of this.
2. You could connect EFG/Trig to AD2 Trigger and trigger on this but in this case you won't see the trigger graphically represented, only as T0
3. You could also connect EFG/Trig to AD2 DIO and use Scope in mixed mode by adding DIO channels and trigger on this.