MissingRedstone Posted June 28, 2021 Share Posted June 28, 2021 Hi, The forums indicate there is a factory calibration applied to the AD2. How long does this calibration officially last? Where can I get into the details of the software-guided calibration? I'd like to know how its generating the multiplicative, additive, and offset values for the WaveGen, Scope and PSU. Thanks, Sam Link to comment Share on other sites More sharing options...
0 JColvin Posted June 30, 2021 Share Posted June 30, 2021 Hi @MissingRedstone, I have moved your question to a more appropriate section of the Forum where the engineer much more familiar with the WaveForms software and the Analog Discovery typically looks. That being said, I don't believe there are details on how the calibration is done specifically. I also haven't seen any official numbers on how long the calibration lasts, likely because it is environment dependent. Thanks, JColvin Link to comment Share on other sites More sharing options...
0 attila Posted July 1, 2021 Share Posted July 1, 2021 Hi @MissingRedstone Please take a look at the following post. Link to comment Share on other sites More sharing options...
0 Johnny Posted November 18, 2021 Share Posted November 18, 2021 I tried following the steps to calibrate my AD2 but the values do not change as I progress through the wizard. It remains 0V throughout the process of checking the waveform generator. What do I do? Reference: How to Calibrate the Analog Discovery 2 - Digilent Projects (digilentinc.com) Link to comment Share on other sites More sharing options...
0 JColvin Posted November 19, 2021 Share Posted November 19, 2021 Hi @Johnny, Presuming the wires were all connected correctly and there was not any pins accidentally connected to ground, and loading the factory calibration does not help, then the WaveForm generator may be damaged. You can contact digilent dot support at ni dot com for warranty options. Thanks, JColvin Link to comment Share on other sites More sharing options...
Question
MissingRedstone
Hi,
The forums indicate there is a factory calibration applied to the AD2.
How long does this calibration officially last?
Where can I get into the details of the software-guided calibration?
I'd like to know how its generating the multiplicative, additive, and offset values for the WaveGen, Scope and PSU.
Thanks,
Sam
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now