I own an Analog Discovery legacy and because of my own stupidity I turned the caps on the PCB....
I asked my dad if he could help, but that didn't work. So my question is: do you have a document where these trimmers are explained. How would I fix and calibrate my AD?
All explanation I found is about the software calibration procedure you can start in waveforms. Found that also on instructables but naturally I should start at the Trimmers.
Question
Raist
hey!
I own an Analog Discovery legacy and because of my own stupidity I turned the caps on the PCB....
I asked my dad if he could help, but that didn't work. So my question is: do you have a document where these trimmers are explained. How would I fix and calibrate my AD?
All explanation I found is about the software calibration procedure you can start in waveforms. Found that also on instructables but naturally I should start at the Trimmers.
any help available?
thanks
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.