Clif Sanchez Posted March 23, 2021 Share Posted March 23, 2021 I've been using my Analog Discovery 2 for a year or so. No problems with the scope or I2C/UART decoding. However, I cannot get any output on the W1 or W2 channels. I'm just trying to create a square wave at 1 kHz. Simple setup. I assume if it states it's running, that I would see an output on W1 or W2, but I don't. This is the first time I've tried to use Wavegen. If I setup Patterns for a 1 kHz signal, DIO3, I see that fine. I feel I must be doing something wrong on the Wavegen setup?? I just upgraded the fw to version 3.14.3 64-bit Qt5.9.7 on a Windows 10 PC. Didn't help. Any insight would be greatly appreciated. Link to comment Share on other sites More sharing options...
attila Posted March 23, 2021 Share Posted March 23, 2021 Hi @Clif Sanchez Make sure you have connected the correct wires. See the following guide:https://reference.digilentinc.com/reference/instrumentation/analog-discovery-2/getting-started-guide Please attach photo with your wiring setup and screenshot from the Scope and Wavegen. Link to comment Share on other sites More sharing options...
Question
Clif Sanchez
I've been using my Analog Discovery 2 for a year or so. No problems with the scope or I2C/UART decoding.
However, I cannot get any output on the W1 or W2 channels. I'm just trying to create a square wave at 1 kHz.
Simple setup. I assume if it states it's running, that I would see an output on W1 or W2, but I don't.
This is the first time I've tried to use Wavegen.
If I setup Patterns for a 1 kHz signal, DIO3, I see that fine. I feel I must be doing something wrong on the Wavegen setup??
I just upgraded the fw to version 3.14.3 64-bit Qt5.9.7 on a Windows 10 PC. Didn't help.
Any insight would be greatly appreciated.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.