Feature Request: Aggregation of Logic Analyzer Channels to show Parallel ADC Values

[Hornzymush]

Hi, 

While the Logic Analyzer mode supports Bus mode, I would like to request for the capability to display the waveform of the values captured (and signal inversion due to possible use of inverting buffer in the front-end). This can be useful for analyzing ADC outputs. Attached is a sample from another software. 

Alternatively, this should also be achievable in the oscilloscope mode but I suppose it might be too troublesome to implement.

[attila]

Hi @Hornzymush

In Logic Analyzer, if you make the Bus (or any other interpreter) row taller it will draw the waveform of its values.
You can also use the Scope in mixed signal mode by adding digital signals, bus or any other interpreter under "Add Channel".
This way, you can see the analog and digital signals, waveforms at the same time.

[Hornzymush]

1 hour ago, attila said:

Hi @Hornzymush

In Logic Analyzer, if you make the Bus (or any other interpreter) row taller it will draw the waveform of its values.
You can also use the Scope in mixed signal mode by adding digital signals, bus or any other interpreter under "Add Channel".
This way, you can see the analog and digital signals, waveforms at the same time.

Hi Attila, 

Thank you for the information! 

[Hornzymush]

20 minutes ago, Hornzymush said:

Hi Attila, 

Thank you for the information!