Conny Posted October 23, 2020 Share Posted October 23, 2020 I would like to use AD2 as DAQ to substitute NI 6008 to make Pressure measurements (with Honeywell ABP series pressure sensor) How can I configure AD2 to read from this sensor? Link to comment Share on other sites More sharing options...
JColvin Posted October 26, 2020 Share Posted October 26, 2020 Hi @Conny, I presume you are looking one of the sensors from this list, https://sensing.honeywell.com/sensors/amplified-board-mount-pressure-sensors/basic-ABP-series? I glanced through the overall datasheet for that particular product line and the Analog Discovery 2 could be used to work with them as the sensors output voltages and logic levels are within the AD2's limits. What I don't know (since I didn't put a lot of time into looking into it) was how to initiate a reading from the sensor or if it continually provides information at a set data rate, but the AD2 and the WaveForms software is capable of reading from it. Let me know if you have any questions. Thanks, JColvin Link to comment Share on other sites More sharing options...
Conny Posted October 29, 2020 Author Share Posted October 29, 2020 thank you. I will look into this. Link to comment Share on other sites More sharing options...
Question
Conny
I would like to use AD2 as DAQ to substitute NI 6008 to make Pressure measurements (with Honeywell ABP series pressure sensor) How can I configure AD2 to read from this sensor?
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.