JTAG-SMT2-NC

[Leo_W]

Hi Digilent,

I used DIGILENT JTAG-SMT2-NC on my board , Now I have a strange problem!!!

When I use “Digilent Adept”,  I can use this module to program ,

As you can see, everything is right!

!But!  When I use VIVADO2018.3 , there are problems as shown in the figure below,The jtagsmt2 shown in the picture is because the firmware was flashed with DigilentFTDIConfig, but the situation of not flashing and flashing the firmware is the same

Quote

 

TCL LOG :

open_hw_target

INFO: [Labtoolstcl 44-466] Opening hw_target localhost:3121/xilinx_tcf/Digilent/210251A08870

ERROR: [Labtools27-2269]No devices detected on target localhost:3121/xilinx_tcf/Digilent/210251A08870.

Check cable connectivity and that the target board is powered up then

use the disconnect_hw_server and connect_hw_server to re-register this hardware target.

ERROR: [Common 17-39] 'open_hw_target' failed due to earlier errors.

 

 

Has anyone ever had a similar problem? Please help. Thank you!

 

[JColvin]

Hello,

 

I responded to your other thread here.

 

Thanks,
JColvin