I am very new to fpgas and vivado but have been playing around with the Arty S7 board for a little while now. I have used the pushbutton/switches and LED GPIOs pretty easily with the block diagram design and controlling them in SDK. I am having difficulty figuring out how to use another pin on the S7 board (ie pin L17) as an input. Do I need to set this up with AXI GPIO, or can I just create an interface port with this pin? How do I configure this with the constraint file and then ultimately how do I initialize it in SDK? Thanks for any information.
Question
Erick
Hello,
I am very new to fpgas and vivado but have been playing around with the Arty S7 board for a little while now. I have used the pushbutton/switches and LED GPIOs pretty easily with the block diagram design and controlling them in SDK. I am having difficulty figuring out how to use another pin on the S7 board (ie pin L17) as an input. Do I need to set this up with AXI GPIO, or can I just create an interface port with this pin? How do I configure this with the constraint file and then ultimately how do I initialize it in SDK? Thanks for any information.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.