I am doing little experiments with old analog discovery and matlab via the data acquisition toolbox add-on. But I try to use the simulink data acquisition blocks intead of using script based approach. I can create a signal generator and generates data from simulink via Analog Discovery out to the world and do the same vice versa. Which means display anything which comes through the scope inputs. But the problem is, I cannot do this at the same time. I think the problem is with the session. Thus, each block (A/D or D/A) opens its own session and some collision appears.
My question is: any hack or workaround this thing?
Question
Bartt
Hi guys!
I am doing little experiments with old analog discovery and matlab via the data acquisition toolbox add-on. But I try to use the simulink data acquisition blocks intead of using script based approach. I can create a signal generator and generates data from simulink via Analog Discovery out to the world and do the same vice versa. Which means display anything which comes through the scope inputs. But the problem is, I cannot do this at the same time. I think the problem is with the session. Thus, each block (A/D or D/A) opens its own session and some collision appears.
My question is: any hack or workaround this thing?
Thanks a lot guys
Bartt
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.