Due to a migration from windows 7 to Linux CenOS6.10, I experience driver problems with adept (and of course also ISE14.7). CentOS6.10 runs through Virtualbox 6.0.4 with appropriate guest additions, and filters for selected Digilent USB devices.
I have followed Xilinx procedure AR# 68233 for driver installation with CentOS6, and installed latest adept runtime and utilities, with the rpms provided.
The installation messages of Xilinx drivers are all OK :
--install_xpc4drvr rc = 0
--Module windrvr6 is running.
--Module xpc4drvr is running.
--Note: By default, the file permission of /dev/windrvr6 is enabled for the root user only
and must be changed to allow access to other users.
Question
Grensv
Due to a migration from windows 7 to Linux CenOS6.10, I experience driver problems with adept (and of course also ISE14.7). CentOS6.10 runs through Virtualbox 6.0.4 with appropriate guest additions, and filters for selected Digilent USB devices.
I have followed Xilinx procedure AR# 68233 for driver installation with CentOS6, and installed latest adept runtime and utilities, with the rpms provided.
The installation messages of Xilinx drivers are all OK :
--install_xpc4drvr rc = 0
--Module windrvr6 is running.
--Module xpc4drvr is running.
--Note: By default, the file permission of /dev/windrvr6 is enabled for the root user only
and must be changed to allow access to other users.
--File /sbin/fxload exists.
--Digilent Return code = 0
--Xilinx Return code = 0
--Return code = 0
--Driver installation successful.
I use 3 products :
All cables enumerate with djtgcfg enum, but only CoolRunnerII can init. Both spartan3 boards return the same error :
ERROR: unable to open device "DOnbUsb" or ERROR: unable to open device "DCabUsb"
Here is the dump of djtgcfg init commands :
[root@localhost ~]# djtgcfg enum
Found 1 device(s)
Device: Cr2s2
Product Name: CoolRunner 2 Starter 2
User Name: Cr2s2
Serial Number: 10146D458839
[root@localhost ~]# djtgcfg -d Cr2s2 init
Initializing scan chain...
Found Device ID: 16d4c093
Found 1 device(s):
Device 0: XC2C256
[root@localhost ~]# djtgcfg enum
Found 1 device(s)
Device: DOnbUsb
Product Name: DOnbUsb1 V2.0
User Name: DOnbUsb
Serial Number: 10054D136360
[root@localhost ~]# djtgcfg -d DOnbUsb init
ERROR: unable to open device "DOnbUsb"
[root@localhost ~]# djtgcfg enum
Found 1 device(s)
Device: DCabUsb
Product Name: DCabUsb1 V2.0
User Name: DCabUsb
Serial Number: 50003C009256
[root@localhost ~]# djtgcfg -d DCabUsb init
ERROR: unable to open device "DCabUsb"
Thanks for your Help.
Vincent.
Link to comment
Share on other sites
7 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.