Tifei Posted May 16, 2019 Share Posted May 16, 2019 Hi, I read few messages on the forum but I would like to confirm if my understanding is right. I have a Digilent JTAG HS-2 cable. I installed Digilent Adept 2. I have my Xilinx FPGA BSDL file. I installed Vivado. Can I do boundary scan with above "weapons"? What I want to do is run BSDL to check my FPGA pin connectivity and to see if the FPGA is good or bad. From the Forum research the answer is NO. Do I understand this correctly? Please advice, thank you. Link to comment Share on other sites More sharing options...
jpeyron Posted May 16, 2019 Share Posted May 16, 2019 Hi @Tifei, I would guess you have seen this thread here. The adept software is not design to facilitate the usage of BSDL Files with the JTAG-HS2. I would suggest reaching out to Xilinx about Vivado. best regards, Jon Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.