amitlwaghmare Posted May 10, 2019 Share Posted May 10, 2019 Hello, I am trying to do this tutorial http://igorfreire.com.br/zynq-ethernet-interface-zybo-board/#Hardware_Design_in_the_ZYBO_board but the output is : Entering into main() Error detect phy Length mismatch Emacps intr dma Example Failed please guide me with this example design. thanks in advance Link to comment Share on other sites More sharing options...
jpeyron Posted May 10, 2019 Share Posted May 10, 2019 Hi @amitlwaghmare, I believe you need to remove the lines shown in the attached screen shot. Are there any warnings or errors in the sdk? Have you contacted the maker of the tutorial about this issue? best regards, Jon Link to comment Share on other sites More sharing options...
Question
amitlwaghmare
Hello,
I am trying to do this tutorial
http://igorfreire.com.br/zynq-ethernet-interface-zybo-board/#Hardware_Design_in_the_ZYBO_board
but the output is :
Entering into main()
Error detect phy
Length mismatch
Emacps intr dma Example Failed
please guide me with this example design.
thanks in advance
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.