I'm trying to boot petalinux on the Z7-20 board and after following the instructions in the github page, I am running into an error. After putting the SD card into the board and starting the boot process, it says there is a command not found. Do I need to try redownloading the packages in case an error occurred doing this?
I'm running this off of Ubuntu 2017.4 and I know there were issues with the locale checks where I had to edit those files in order to bypass.
Thank you for the help
EDIT: So I found my issue with talking with the board was just that i didn't change my minicom settings so that it was no Hardware Flow
Question
michaelgood411
I'm trying to boot petalinux on the Z7-20 board and after following the instructions in the github page, I am running into an error. After putting the SD card into the board and starting the boot process, it says there is a command not found. Do I need to try redownloading the packages in case an error occurred doing this?
I'm running this off of Ubuntu 2017.4 and I know there were issues with the locale checks where I had to edit those files in order to bypass.
Thank you for the help
EDIT: So I found my issue with talking with the board was just that i didn't change my minicom settings so that it was no Hardware Flow
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.