I am trying to program a ZedBoard in Vivado 2018.3 under Windows 10 Pro. The board is connected to my PC both via UART (which is up and running) and via micro USB-JTAG (basically the connector J17-PROG).
The problem is that in Vivado "Hardware Manager" I can't see the board (localhost has 0 devices).
In Windows>Device Manager I can only see the UART device but nothing related to the JTAG.
I also tried to install,in admin mode, the cable drivers located in the folders:
Question
Raff
Hi all,
I am trying to program a ZedBoard in Vivado 2018.3 under Windows 10 Pro. The board is connected to my PC both via UART (which is up and running) and via micro USB-JTAG (basically the connector J17-PROG).
The problem is that in Vivado "Hardware Manager" I can't see the board (localhost has 0 devices).
In Windows>Device Manager I can only see the UART device but nothing related to the JTAG.
I also tried to install,in admin mode, the cable drivers located in the folders:
Xilinx\Vivado\2018.3\data\xicom\cable_drivers\nt64
Xilinx\Vivado\2018.3\data\xicom\cable_drivers\nt64\Digilent
Xilinx\Vivado\2018.3\data\xicom\cable_drivers\nt64\dlc10_win10
But still doesn't work.
Thanks for any advice
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.