kojak Posted December 1, 2018 Share Posted December 1, 2018 Hello @attila Can you add an option into protocol trigger to trigger when value is in or out of defined range? This will be helpful when finding strange values on bus. Thank you Link to comment Share on other sites More sharing options...
attila Posted December 3, 2018 Share Posted December 3, 2018 Hi @kojak I'm not sure when such option will be added, it would required "firmware" modifications. At the moment you could trigger on range by masking bits. For this press Alt+F11 to have no-limits mode, open Logic Analyzer configure a protocol to trigger on a specific value, press the Advanced button and modify the mask and value. Note that after modifying the signals or trigger in the LA window you will have to reconfigure this advanced trigger option. Here for instance with value and mask of hF0 it triggers on hFX, 240...255 Link to comment Share on other sites More sharing options...
kojak Posted December 5, 2018 Author Share Posted December 5, 2018 Hi @attila It is ok now because for now I am unable to set even Protocol trigger to value for instance 0x00A3 at the third position. Link to comment Share on other sites More sharing options...
Question
kojak
Hello @attila
Can you add an option into protocol trigger to trigger when value is in or out of defined range? This will be helpful when finding strange values on bus.
Thank you
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.