I'm trying to figure out how I can use the onboard flash memory (PC28F512G18A) for my bitstream file. On the boards I used before I either had an parallel flash directly connected to the FPGA or the flash was inside the JTAG chain. But on the NetFPGA Board there is a CPLD (XC2C512) inbeteween the FPGA and the Flash Memory. I found a guide for the NetFPGA-10G Board, but it does not seem to fit to the SUME board.
Question
Holger
Hi,
I'm trying to figure out how I can use the onboard flash memory (PC28F512G18A) for my bitstream file. On the boards I used before I either had an parallel flash directly connected to the FPGA or the flash was inside the JTAG chain. But on the NetFPGA Board there is a CPLD (XC2C512) inbeteween the FPGA and the Flash Memory. I found a guide for the NetFPGA-10G Board, but it does not seem to fit to the SUME board.
https://github.com/NetFPGA/NetFPGA-public/wiki/NetFPGA-10G-Flash-Configuration
On the SUME Board i couldn't locate the SW3 or something similar.
So, how can I programm the (not directly) attached flash memory with my FPGA firmware file?
Regards
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.