I am trying to build a wifi communication between Zedboard and Raspberry Pi. I referred to this link: https://www.youtube.com/watch?time_continue=8&v=KTeTMv3oiPw. At the very beginning, I encountered an issue when building customize the MIG core.
The target is set to digilent Zedboard (xc7z020clg484-1).
I have added the board library.
There is no memory selection under the board, so I tried to initialize the MIG by myself. Then in the constraints section, I cannot find the corresponding pins according to the schematic.
I would like to know if there is any way to solve it. Thanks a lot!
Question
conanandai100
Hi,
I am trying to build a wifi communication between Zedboard and Raspberry Pi. I referred to this link: https://www.youtube.com/watch?time_continue=8&v=KTeTMv3oiPw. At the very beginning, I encountered an issue when building customize the MIG core.
The target is set to digilent Zedboard (xc7z020clg484-1).
I have added the board library.
There is no memory selection under the board, so I tried to initialize the MIG by myself. Then in the constraints section, I cannot find the corresponding pins according to the schematic.
I would like to know if there is any way to solve it. Thanks a lot!
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.