I am looking for a method of creating cables for the Nexsys4 DDR boards to connect multiple boards together via the PMOD and a cable to connect to my specific debugger probe. I have found this connector
and made several cables. It works but is not completely satisfactory. The issue is the mechanical connection between this male connector and the female PMOD is not reliably secure, especially for high speed signals.
Question
mgravenstein
I am looking for a method of creating cables for the Nexsys4 DDR boards to connect multiple boards together via the PMOD and a cable to connect to my specific debugger probe. I have found this connector
http://www.ebay.com/itm/171330540572?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
and made several cables. It works but is not completely satisfactory. The issue is the mechanical connection between this male connector and the female PMOD is not reliably secure, especially for high speed signals.
Does anyone have a solution other than two of these https://store.digilentinc.com/pmodtph2-12-pin-test-point-header/ plus two of these http://www.amazon.com/Accessories--Connectors-25-Pack-Sockets-Connectors/dp/B015E5MPYY/ref=sr_1_3?s=electronics&ie=UTF8&qid=1456182709&sr=1-3&keywords=2x6+pin+idc+connector connected to the breakout header.
Thanks.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.