Sleepy Engineer

Hi @JColvin Thank you so much for your assistance. The additional models would be very helpful, but if you can't the following measurements denoted with a ? would be a big help. Basically, I am try to make trays to mount them and hold them in place. I did find some measurements on their pages. I am including them here in case someone else is in my situation. Are widths on the pmod resource pages for the board or the whole unit? pmod CAN: Width 1.4 in (3.556 cm) Length 1.8 in (4.572 cm) Max Height (bottom of board to highest component OR board width and tallest component height) ? clearance between DB9 and board or is it flush with the board? distance DB9 sticks out ? distance PMod pins stick out ? pmod ToF (imagine you are trying to put this in a box and need the sensors to be usable) Width 0.8 in (2.032 cm) Length 1.6 in (4.064 cm) Max Height (bottom of board to highest component OR board width and tallest component height) ? diameter of LD1 and D1 ? Distance to bottom of LD1 and D1 from an edge (pick one as a reference and I can work off that) ? ? pmod ESP32 Width 0.80 in (2.03 cm) - Does this include the antenna? If not, how far does the antenna stick out? antenna width? Length 2.0 in (5.08 cm) Max Height (bottom of board to highest component OR board width and tallest component height) ? Thank you again!

Hello, Can y'all upload the .step files for the following PMODs? I could not find them. ACL2 CAN CMPS2 CON3 MAXSONAR ToF IR Sensor WIFI ESP32 Thanks!