cactuskooler

Hi JColvin, I was able use this part ordered on Amazon. 20 Pcs 5mm High Knob Vertical Slide Switch 3 Pin 2 Position 1P2T SPDT Panel (Pack of 20) CYT1107 (see picture) Thanks and Regards Steve

Hello JColvin, I also have issues with connecting the USB to UART with Zedboard rev. D I installed the CypressDriverInstaller_1 I'm running Windows 10 PRO and Device Manager does not detect Cypress USB to Serial Adapter or Cypress Serial (Com) (see picture) Rebooting Windows and re-installing as Admin does not change the outcome. My Jumpers 5 MIO jumpers arranged as follows (see picture) MIO2 (JP7) - GND MIO3 (JP8) - GND MIO4 (JP9) - 3.3V MIO5 (JP10) - 3.3V MIO6 (JP11) - GND VADJ set to 1.8 V, not sure about JP6 and JP2 near the microUSB ports both loaded), and a cable connected to J14 (UART). I see power LED (LD13) and then subsequently power LED (LD12) both turn on as well as the OLED display. (see picture) If I connect the HDMI cable I see two penguins on the screen. I verified that the SD card contains the sd_image: -- BOOT.BIN – Zynq configuration file that was generated using the 3 files found in the boot_image folder. -- devicetree_ramdisk.dtb – Prebuilt device tree -- ramdisk8M.image.gz – Prebuilt Linux filesystem -- README – readme document that describes how to run the OOB design -- zImage – Prebuilt Linux kernel Any help would be appreciated. Thanks and Regards Steve

The Zedboard slide switch (power on/off) broke. Can anyone provide a part number to replace? Thanks and appriciated.