Ayesha Zaman

Hello All I was wondering if AD2 is the LABVIEW driver for Analog Discovery 3 as well? If not which is the relevant drive for Oscilloscope using Analog Discovery 3 , FPGA please? Thanks in advance. Regards Ayesha Zaman

Thank you for the feedback ! Are you referring to Buffer size of the DUT (device under test) being tested please? thank you

Good Afternoon All, I am working on some test and analysis using Digilent discovery 2, I have designed a LABVIEW VI for Digilent MSO (Oscilloscope), in practical the FPGA could not hit the maximum sampling rate of 100 Ms/s , rather it goes uoto maximum 50 Ms/s. Anyone would please suggest how to resolve the issue? Thank you. Regards Ayesha Zaman

Good Afternoon I am trying to design a Digital Oscilloscope for the Digilent Discovery FPGA system using labview. I have the AD2 and Digilent Waveforms VI installed as the Instrument Driver in Labview. But I need to modulate the Resolution Bandwidth (RBW) for the Oscilloscope design. I find two algorithms being used as FFT and CZT within Waveforms. By passing Waveforms software I will be designing the VI using labview , where I should be able to vary the Resolution Bandwidth for the Digital Oscilloscope . Do I need to install any other driver for the design? I would highly appreciate your feedback please. Thank you so much. Regards Ayesha Zaman

Hello All I am a new user both with LABVIEW and Digilent Discovery 2 , FPGA system. I am having trouble to communicate between LABVIEW and the connected DIGILENT DISCOVERY 2 , FPGA as connected with USB port. I have installed both AD2 and Digilent Waveforms VI . Unfortunately I am not able to see the connected hardware at the USB through NI MAX. Do I need any extra driver to communicate between LABVIEW and Digilent FPGA at this point please? I would highly appreciate your feedback Please. Thank you. Ayesha Zaman