Jerin James

Hi, Power is Up on Eclypse Z7 board. Getting like below after connecting USB cable:

Hi, We are using Eclypse Z7. For debugging purpose, tried connecting USB A to Micro A cable and Jumper(JP5) is kept at JTAG mode. But device is not detecting at Vivado HW manager. We are using Vivado Lab edition 2023.2. Is it required to enable all FPGA banks for device detection. Please guide.

We are able to write and read back PLATFORM_CONFIGURATION(0x8004) register using i2c commands But facing issues with VADJ_A_OVERRIDE 0x804E. Like write is happening (Tried 0xC000), but while reading getting values always as 0x00. Any idea on this?

Facing issues with dpmutil integration with petalinux 2023. We have gone through Eclypse-PMCU-Specification-Public pdf. As per our understanding we can check VADJs status and override values with I2C also using configuration registers. Same functionality as dpmutil/decutil. Is this understanding is correct ?

As per this figure from Eclypse Z7 manual, does it contain SYZYGY PODs with MCU where DNA information is stored?

if the SYZYGY PODs are not present on both connector side, How to control VADJA and VADJB from platformMCU present in the Eclypse Z7 board?

@Arthur, Is it possible to set up a meeting with you or any Digilent technical support team to clarify our doubts on Eclypse Z7 board bring up?

We are using Eclypse Z7 board. Want to understand how power sequencing is done. In the Reference manual mentioned like, Configuration is preserved by the PMCU in an EEPROM when the Eclypse's power is cycled. Do we need to do any configuration from user side for controlling Bank voltages. etc.