cmartema

Yes, I ended up obtaining another sd card and reimaging it to the latest firmware (v3.0.1). When I switch the jumper JP4 from SD to QSPI, none of the lights end up flashing. I see that the device is detected in coms4. When I try to access the terminal through putty, the device is unresponsive. Is there anything else I can try? .

I am sure you guys have heard this a lot, but I have followed through each thread with similar issues and have not found a solution to the problem. The board was working perfectly before and I recently tried to use it after my soc course and it did not work. I bought a new SD card for it( Sandisk 32GB) and still does not boot. The board only has the red LED on and TX and RX LED do not boot up.