Chr

Is it in general possible to use the Vivado and Petalinux version 2023.2 for the Genesys zu-5ev board?

Hi, thank you for the feedback! The debug output of the FSBL does not work in my setup. I changed the workflow to Vivado and Petalinux version 2020.1 and patch the FSBL with the digilent patch files (https://github.com/Digilent/Genesys-ZU-OS/tree/5ev/oob/master/project-spec/meta-user/recipes-bsp/fsbl). This setup works and the board is booting successfully.

Hi, I am using the Genesys zu-5ev board and trying to build a petalinux image. If I apply the workflow explained below, the error LED on the board is on just after powering the board and no boot screen is visible via the serial port. I am using Vivado 2023.2 and petalinux 2023.2 (same error occurs also on version 2022.1) The following worklflow was applied: - load the latest board file (version C0) - create new Vivado project using the board file - in the Vivado project, I create the block design and just add the zynq ps without modifying the IP - I connect the pl_clk0 output with the axi clk input - validate disign, create HDL wrapper, generate Bitstream and export hardware - on the petalinux workflow i create a petalinux project with zynqMP template and add the .xsa file - petalinux-config without any modifications, petalinux-build and petalinux-package - flash sd-card via dd I tried the same workflow with Vivado and petalinux version 2022.1 with the same result. I red something about fsbl patch but I am not sure which version of petalinux has to be patched. Any help would be great, thanks.

Thank you for your answer, I will give a feedback about my experience.

Hi, I have an Genesys zu-5ev board and I want to use the sfp+ interface. Are there known sfp+ modules which are compatible to the slot on the board? This is the first time I am using such an Interface. Any help would be appreciated.