When I take a test while installing a program instacal, this page appears to me. I searched a lot for the entrance +-VDM did not find it. Can you help me with that?
knowing that I use USB _231 DAQ.
Also, the output signal is limited from -10 to +10. There are some sensors with a 5-volt output. Can the output value be modified in the DAQami program? If not, does it affect the reading of the sensor? I mean, when converting from voltage to millimeter, it is taken on the basis of 5 volts or 10?
Use the program DAQami.Can you explain that to me?