Programmer

Hello @JColvin Thank you very much for the reply. I am aware that if I connect the Basys3 board to the PC, I will not be able to select it in Vivado. When I open a new project, I expect to be able to select the board Basys3 from the list, because I installed the board_files according to the instructions. As shown in the picture below. In my selection list I do not have the Basys3 board it is not there even if I installed again the board_files. This is my problem I can not select the board and the Artix 7 chip at the beginning because I do not see it. Currently I am starting a new project with the wrong board and chip, and this can't be the solution. Thank you and kind regards

Hello together, I have installed the Viviado 2023.1 and connected the Basys3 board. When opening a new project, I could only see the Basys3 at the beginning under "Boards". I installed it, but after that I can't find or see the Basys3 anywhere. I don't know if it was installed at all. Then I created the directory "board_files" and loaded the data, as it says in the instructions https://digilent.com/reference/programmable-logic/guides/installing-vivado-and-vitis#install_digilent_s_board_files. But even after this change, I cannot see the Basys3 board. I can see the Basys3 board on the PC. What am I doing wrong? Many thanks for the help