misscmos

Hi @attila I have another desparate question about reading SPI registers. In this time, I try our "reading only single byte" mode, which is written like the 1st image file. The instruction of the "reading only single byte" mode is "h33" and I would like to read the address of "h0A42". So, I run the Waveforms, like the 2nd image file and then I got the waveforms in the Logic Analyzer, like the 3rd image file. The "MISO" port has no "reading" value from the register in my test chip. Could you please give me an advice to use our "reading only single byte" mode? Best regards, SinNyoung Kim

Hi @attila Thank you very much for your answer and the information about "Logic Analyzer"!!

I hope my elementary-level question does not corrupt this forum. I am using Digital Discovery & Waveforms 3.19.5 version to control SPI on our research test chip. In the document of the SPI embedded into the test chip, the instruction of the SPI control is such like the attached image. The instruction code for "read-write single byte" is h69. For example, I would like to write "h32" in the register address of "h0A42". So, I set the SPI protocol in the Waveforms such like the 2nd attached image. Is this setting correct?