Hello Digilent,
How can one replace the installed micro sd-card?
Background: I have setup a second one to easily switch between projects....
I fact - it seems to be quite impossible... or is there a trick buried in the docs?
Q: Is there some spring mechanism inside, where one requires a needle/screwdriver to push?
In fact - this is a severe drawback assuming that a removable media (SD Card) is removable...
Consider this also as a mechanical complaint (which might lead to a one star comment) ...
next to the installation place of the micro sd-card
the slot is located right in the middle of the board
AND points directly on neighbouring electronics,
on removal of the SD card, the resistors infront seem to have a high risk to get removed
neglecting the fact, that there is sufficient space on the board
And a removable media is not to be used as a removable media
And it seems to be firmly attached
Regards,
Günter