[Labview MSO not reading until re-plugging the header bundle.]

Hi @attila

I manage to fix it by adding time delay between PWS power-on and DIO.

Not sure the problem is, but it has to do with power/IO timing.

Much appreciation for your help.

[Labview MSO not reading until re-plugging the header bundle.]

Hi @attila

I am using 20pin to 20pin jumper cable, so I had to reconnect all of them together. 

I just figured out the problem is the digital I/O. (I am controlling relay using source drive + DIO)

The reading is bad because only one channel of the relay switched.

My suspicion is the drive strength on AD3(default 4mA), where AD2 had 12mA as default.

**Is there any way to set DIO drive through LabView? 

 

 

[Labview MSO not reading until re-plugging the header bundle.]

 

After starting the VI MSO/1 reads correct output but MSO/2 is reading noise.

 

After I disconnect the header and reconnect it, the output fixed itself.

This same code works for AD2 but when I use AD3 I have to re-plug the header.

[ADP 5250 Labview Power Supply issue.]

Hi,

I am running into problem using Digilent Toolkit on Labview.

The Analog Discovery Pro 5250 has three power supply ports, +6V, +25V and -25V. 

The toolkit cannot detect the ports, therefore, throwing an error.

I know that the toolkit for labview has not been updated since 2016, is there any fixes or workaround for writing labview code for the ADP 5250?

Thanks!