AKA

Hi @attila I manage to fix it by adding time delay between PWS power-on and DIO. Not sure the problem is, but it has to do with power/IO timing. Much appreciation for your help.

Hi @attila I am using 20pin to 20pin jumper cable, so I had to reconnect all of them together. I just figured out the problem is the digital I/O. (I am controlling relay using source drive + DIO) The reading is bad because only one channel of the relay switched. My suspicion is the drive strength on AD3(default 4mA), where AD2 had 12mA as default. **Is there any way to set DIO drive through LabView?

After starting the VI MSO/1 reads correct output but MSO/2 is reading noise. After I disconnect the header and reconnect it, the output fixed itself. This same code works for AD2 but when I use AD3 I have to re-plug the header.

Hi, I am running into problem using Digilent Toolkit on Labview. The Analog Discovery Pro 5250 has three power supply ports, +6V, +25V and -25V. The toolkit cannot detect the ports, therefore, throwing an error. I know that the toolkit for labview has not been updated since 2016, is there any fixes or workaround for writing labview code for the ADP 5250? Thanks!