Mackenzie Cox

Here is my board configuration. I have all of my thermocouples set to 60Hz for the data rate. But, all of the thermocouples read fine in Instacal, it is just specific ones that are having issues in labview. I tried out those configurations you attached, same issue.

I have Labview set up to read thermocouple readings from my USB 2416. For some reason, all of the thermocouple channels are giving consistent and accurate measurements in instacal, but when I boot up labview (after closing out instacal), some of my thermocouples are giving extremely inconsistent readings. It is not my block diagram, as I have tried different thermocouples in the same channel I am trying to read and they work fine. I also know it is not my thermocouple because they are working fine when I read them in instacal. Any insight as to what is going on?

I was able to connect this fine, but am still unclear as to where the output wire of the sensor needs to be connected.

I am having a lot of trouble connecting this pressure transducer to my DAQ: https://www.mcmaster.com/3196K327/ Could anyone give me some guidance on how to connect these? I have tried just about everything I can think of...

Going back to the set up of the pressure sensors, I have everything set up, but I am getting a reading that increases linearly with time. Any idea what could be going on here?

Okay, I am looking at other options. I need one that outputs either voltage or current, right?

Do you have any insight on how to hook up these flow rate monitors? https://www.omega.com/en-us/flow-instruments/flow-meters/turbine-flow-meters/bv1000-2000-3000-series/p/BV2000TRN250A

Okay, thank you that is very helpful. Do you have any insight on how to connect this soil moisture sensor as well? I may have to contact the supplier as the wiring diagram does not seem to match reality. There are two additional wires on mine that are not pictured here, but I would be curious to see if you knew how to connect this before I do that. https://www.seeedstudio.com/RS485-Soil-Moisture-Temperature-Sensor-S-Soil-MT-02-p-4634.html

I am using a 0-10VDC output, 4-pole micro M12 Plug, 0-100PSI pressure sensor. I have attached the link to product specs and wiring diagram. https://www.mcmaster.com/3196K327/

I have a pressure sensor that needs a positive and negative voltage in addition to the voltage output to the DAQ. How do I connect the wires to my USB 2416 so that this can function properly?

In order to use my measurement computing DAQ with LabVIEW, I have to have this "ULx for NI LabVIEW" software installed to bridge the gap between the two products. I have to have LabVIEW installed before installing the MC software, which I have done, but the MC software is not recognizing that I have already installed LabVIEW and therefore will not install the software. How can I get it to recognize that I already have LabVIEW installed?