Hello
We are using Analog Discovery 2 as a signal generator in our production test setup. We are able to achieve the correct signal frequencies and amplitudes by adding some attenuators on the output.
One of the compliance requirements of our test setup is the following:
The values used in test circuits, unless otherwise specified, shall have at least an accuracy as given below:–
resistors: ±1 %;
capacitors: ±10 %;
inductors: ±10 %;
test voltages: ±1 %.
Our test circuit is the analog discovery 2 box and no other components. So which one of the above requirements are met by your hardware?
I look forward to your response.
Regards
Ankit