Alex Posted March 30, 2015 Share Posted March 30, 2015 Hi, a customers has question about how to secure the power terminal in the large breadboard we sell. (see below email). Hi, I ordered this item as part of a recent order: 424-BB-KIT-LARGE The item has a design flaw which means that the power terminal pins cannot be mounted onto the back board securely. To mount the power terminals one must align 2 washers on either side of the backboard. These washers have cut outs that match slots in the board hole. Unfortunaly because the back board is too thin these washers can never be mounted properly and the each power terminal wobbles even when aligned correctly and tightened appropriately. The fault would is obvious to anyone trying to assemble the item and it does seem disappointing that this board was clearly never tested before being sold to customers - unless of course the manufacturer has reduced the thickness of the backboard between pre-production samples and the production run. Here are instructions: 1) Take out the nut and washer from the power terminal 2) Insert the terminal into the hole on the board (e.g. the black one for the ground) 3) Put the washer back on the back of the board 4) Put the nut on top of the washer and fasten it. 5) Flip the board and fasten the top of the terminal Link to comment Share on other sites More sharing options...
Commanderfranz Posted May 29, 2015 Share Posted May 29, 2015 Hi Alex, I am re-posting this answer so forum users can see that this question has been answered. ____________________________________________________________________________________ Here are instructions: 1) Take out the nut and washer from the power terminal 2) Insert the terminal into the hole on the board (e.g. the black one for the ground) 3) Put the washer back on the back of the board 4) Put the nut on top of the washer and fasten it. 5) Flip the board and fasten the top of the terminal Link to comment Share on other sites More sharing options...
Question
Alex
Hi, a customers has question about how to secure the power terminal in the large breadboard we sell. (see below email).
Hi, I ordered this item as
part of a recent order: 424-BB-KIT-LARGE The item has a design flaw which
means that the power terminal pins cannot be mounted onto the back board
securely. To mount the power terminals one must align 2 washers on either
side of the backboard. These washers have cut outs that match slots in the
board hole. Unfortunaly because the back board is too thin these washers
can never be mounted properly and the each power terminal wobbles even
when aligned correctly and tightened appropriately. The fault would is
obvious to anyone trying to assemble the item and it does seem
disappointing that this board was clearly never tested before being sold
to customers - unless of course the manufacturer has reduced the thickness
of the backboard between pre-production samples and the production run.
Here are instructions:
1) Take out the nut and washer from the power terminal
2) Insert the terminal into the hole on the board (e.g. the black one for the ground)
3) Put the washer back on the back of the board
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.