Its been a few months since I've been introduced to FPGA design and have successfully completed some basic projects, however, while trying to effectively establish communication with devices via protocols such as uart, spi, and i2c I usually fall short. From what I understand you must enable these through the ZYNQ7 processor on block design or drop in their respective IP blocks. How to actually connect these to external devices becomes fuzzy for me and interpreting/modifying the SDK code is very difficult. In short I'm looking for some help/resources to get the ball rolling on these type of projects, and how to actually understand/develop the C code for processor myself, on both the Microzed and Zybo development boards.
Question
smutlu1
Its been a few months since I've been introduced to FPGA design and have successfully completed some basic projects, however, while trying to effectively establish communication with devices via protocols such as uart, spi, and i2c I usually fall short. From what I understand you must enable these through the ZYNQ7 processor on block design or drop in their respective IP blocks. How to actually connect these to external devices becomes fuzzy for me and interpreting/modifying the SDK code is very difficult. In short I'm looking for some help/resources to get the ball rolling on these type of projects, and how to actually understand/develop the C code for processor myself, on both the Microzed and Zybo development boards.
Thank you
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.