ADP3450 Boot issue

[BRam]

Power LED on ADP 3450 keeps blinking at 1hz and does not become steady. Device has previously worked without any issues. Powering on the system with the reset button pressed causes the LED to be steady but the device is not detected by waveforms. Power has been cycled a number of times with no change in blinking light. The device is detected by the Mac that it is connected to and the information below is given by sysinfo. 

FT232R USB UART: 

  Product ID: 0x6001

  Vendor ID: 0x0403  (Future Technology Devices International Limited)

  Version: 6.00

  Serial Number: AU05XCCY

  Speed: Up to 12 Mb/s

  Manufacturer: FTDI

  Location ID: 0x01132000 / 6

  Current Available (mA): 500

  Current Required (mA): 90

  Extra Operating Current (mA): 0

Any Advice on a remedy to get the ADP3450 working again is welcome. Thanks in advance!

Edited 18 hours ago by BRam

[attila]

Hi @BRam

Probably the embedded Linux was messed up.
Reset and send any character except L, then in WaveForms select Standard boot mode, or use USB recovery for Linux.
See the Help tab: