I am using the AD3 via SDK to generate a ~200 Hz sine wave. Depending on some measurement & claculation, I do adjust the frequency via FDwfAnalogOutNodeFrequencySet. Frequency Increments/Decrements can be as low as some mHz. Now I see, that always when setting the frequency, the waveform stops for ~2ms before it restarts with the newly set frequency.
Now I have two questions:
Is there a way to change the frequency 'randomly' from the SDK, without stoping the waveform for every new frequency?
Can this somehow be done on both output channels synchronously, by keeping a constant phase-shift between CH1 & CH2?
Question
StefKay
Hello,
I am using the AD3 via SDK to generate a ~200 Hz sine wave. Depending on some measurement & claculation, I do adjust the frequency via FDwfAnalogOutNodeFrequencySet. Frequency Increments/Decrements can be as low as some mHz. Now I see, that always when setting the frequency, the waveform stops for ~2ms before it restarts with the newly set frequency.
Now I have two questions:
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now