Device config version miss match error after network configuration

[LuisP]

Hello! We are trying to configure our ADP3450 to stream data via ethernet using a Linux Alma9 system. For that we tried to configure the IPAdress, Subnet Mask and Gateway of the device to match fixed ones, using a laptop with macOs 14.4.1 and Waveforms 3.22.2.

We connected the device using the USB connector and followed the instructions on https://digilent.com/reference/test-and-measurement/analog-discovery-pro-3x50/ethernet-streaming to configure the ethernet. Then we applied the changes.

After that we heard a clicking sound but if we try to access the network tab again this error pops up:

Once this message appears waveforms crashes and if we try to open it again the USB connection is gone. After that the program freezes and crashes again. If we restart the Oscilloscope waveforms stops crashing and the USB connection is restored.

We also tried to do this from a Linux laptop with similar results. This is our second post on this topic, as we couldn't solve the issue yet and we had no response on the original post. Here the original post ca be found:

We have two question in this regard:

Why is this error popping up?
Is the ethernet configuration correctly saved?

Thank you

[attila]

Hi @LuisP

The lister ID and version are not valid values. It seems to be communication problem, data corruption.
Is the device working with USB connection from a computer ?

Sorry for the later response, but I'm on vacation.
 

[LuisP]

3 hours ago, attila said:

Hi @LuisP

The lister ID and version are not valid values. It seems to be communication problem, data corruption.
Is the device working with USB connection from a computer ?

Sorry for the later response, but I'm on vacation.
 

Hi, the device gets automatically connected to the application when using USB, we haven't tried to take data yet but it seems to work fine when connected by USB, it The error occurs when trying to configure the ethernet connection.

Edited June 4 by LuisP

[attila]

Hi @LuisP

I think I've managed to reproduce something similar... I'm working on it.

[LuisP]

Thanks @attila, looking foward to your response!

[attila]

Hi @LuisP

I hope the following will solve the problem:

 

[LuisP]

Hi @attila the Mac version is not available for download, is there any way of obtaining it?

 

[attila]

Hi @LuisP

Working on updating the certificates...

[attila]

Hi @LuisP

Mac build is now available